Measuring For Your Case:
First... find a marker and a big piece of paper (an unfolded paper bag works well).
(See special notes on hammered dulcimer & harp cases below.)

1.) Lay your instrument down and trace the outline. Stand it up and trace the base (if it has a base.)

2.) Measure the depth of the instrument in as many places as needed (ends, bridge, pegs, etc.) Write the measurments along the outline.

3.) Mark any potential rub spots where strings, pegs and bridges may wear the lining.

4.) Pick up your instrument and find where it is most easily carried, the balance point. Mark that on the tracing.

5.) Put your name, UPS address, phone number and any other details on the tracing.

1.) Lay the case on a piece of paper and trace the outline. Mark the handle and hinges.

2.) Measure the depth(s) and write them on the outline.

3.) Put your name, UPS address, phone number and any other details on the tracing.

I have never met two harps of different makers that are the same.  Each of my cases are custom built for you and your harp’s needs.  Most important is the placement of the handles. If you are sending a tracing please do not forget to mark this balance point along the pillar.  If you have a preference as to the orientation of the pocket please note that as well.  Sometimes it is impossible to put a grab handle on the side of the case when the pocket is one way or the other, depending on this very important balance point.

Some examples of the cost to protect your instrument: